Sending Programs and Lookup Data to the M5900

Sending Data to the M5900

If you haven't already done so, configure and connect your M5900 to your PC.

Note: Resending a program to your M5900 will overwrite any capture data you have collected to that point. Be sure to retrieve your Capture Data before resending a program already on your device.

Select Tools, Send current programs and data to M5900

or press the Upload current programs and data to the M5900 button

You will get the following Dialog Box:

If your M5900 has been configured for Auto Upload, press the OK button.

Otherwise:

If you have not configured your M5900 for Auto Upload, you need to do the following:

Now you can press the OK button on your PC.

Your progam is being sent to the M5900!

If you can not get to this point, see Connecting the M5900 to Your PC

On your PC you should see the communications dialog:

On you M5900 you should see the communications window:

Once the trasfer is complete, the device will unpack your program and install it into the M5900 filesystem.

Press any key on your device to continue.

Now you can run your program on your M5900.

Back to Getting Started